Dell PowerConnect 55xx Systems User Guide 341
Auto Update Configuration through the GUI
To set the auto update and configuration parameters:
. NOTE: For the automatic options in this page to work the following must be
implemented:
• Since Auto-Config depends on retrieving information from a DHCP server, the
startup configuration needs to include a DHCP IP interface. The device is
defined as a DHCP client, as described in "DHCP IPv4 Interface" on page 207.
After reboot, this command is not saved in the Startup configuration.
• Preparations described above must be completed on the DHCP server and
TFTP servers.
1
Click
System
>
File Management
>
Auto Update of
Configuration/Image File
in the tree view to display the
Auto Update of
Configuration/Image File
page.
Figure 9-54. Auto Update of Configuration/Image File
To Next Page
Loading...
