Dell POWERCONNECT 5524P - Page 343

Dell PowerConnect 55xx Systems User Guide 343
The following is an example of the CLI command to view the Auto-Update
status:
boot host dhcp
no boot host dhcp
Forces the mechanism used to
download a configuration file at the
next system startup.
Use the no form of this command to
restore the host configuration file to the
default.
boot host auto-save
no boot host auto-save
Enables automatic saving of Running
configuration in Startup configuration
after download.
Use the no form of this command
restore default behavior
show boot Shows the status of the IP DHCP Auto
Config process.
console# show boot
Auto Config
-----------
Config Download via DHCP: enabled
Next Boot Config Download via DHCP: force
Auto Update
-----------
Image Download via DHCP: enabled
Table 9-63. Auto Update of Configuration/Image File CLI Commands (Continued)
CLI Command Description