Dell POWERCONNECT 5524P

348 Dell PowerConnect 55xx Systems User Guide
– Link Local Interface — When the server supports an IPv6 Link Local
address, this specifies the Link Local interface. The possible options
are:
•
VLAN — The VLAN on which the IPv6 interface is configured.
•
ISATAP — The IPv6 interface is configured on an ISATAP
tunnel.
3 Select a Firmware/Configuration option. The possible options are:
–
Firmware Download — A firmware file is downloaded.
–
Configuration Download — A configuration file is downloaded.
4 Select to download firmware or a configuration file via a TFTP server in
Download Protocol .
5 If the Firmware Download option was selected, enter the following:
–
Server IP Address — The IP address of the server from which the
firmware file is downloaded.
–
Source File Name (1-64 characters) — The file to be downloaded.
–
Destination File Type — The destination file type to which the file is
downloaded. The possible options are:
•
Software Image — Downloads the Image file. The image file
overwrites the non-active image. It is recommended to designate
that the non-active image becomes the active image after reset,
and then to reset the device following the download. During the
Image file download a dialog box opens that displays the
download progress. The window closes automatically when the
download is complete.
•
Boot Code — Downloads the Boot file.
6 If the Configuration Download option was selected, enter the following:
–
Server IP Address — The TFTP server IP address from which the
configuration files are downloaded.
–
Source File Name (1-64 characters) — The configuration file to be
downloaded.