352 Dell PowerConnect 55xx Systems User Guide
–
Link Local Interface
— When the server supports an IPv6 Link Local
address, this specifies the Link Local interface. The possible options
are:
•
VLAN
— The VLAN on which the IPv6 interface is configured.
•
ISATAP
— The IPv6 interface is configured on an ISATAP
tunnel.
3
Select one of the options:
–
Firmware Upload
— A firmware file is uploaded.
–
Configuration Upload
— A configuration file is uploaded.
4
Select to upload firmware or a configuration file via a TFTP server in
Download Protocol
.
5
If
Firmware Upload
was selected, enter:
–
TFTP Server IP Address
— The TFTP server IP address to which the
software image is uploaded.
–
Destination File Name (1-64 Characters)
— The file name to which
the file is uploaded.
6
If
Configuration Upload
was selected, enter:
–
TFTP Server IP Address
— The TFTP server IP address to which the
configuration file is uploaded.
–
Destination File Name (1-64 Characters)
— The configuration file
name/path to which the file is uploaded.
–
Transfer File Name
— The configuration file that is uploaded. The
possible options are:
•
Running Configuration
— Uploads the Running Configuration
file.
•
Startup Configuration
— Uploads the Startup Configuration file.
•
User-defined Files
—
Uploads the selected file. A user-defined
file is only displayed in this list if one was previously created by a
user, for example, if the user copied the running configuration file
to a user-defined configuration file called BACKUP-SITE-1, the
BACKUP-SITE-1 configuration file is displayed in the list and can
be selected.
7
Click
Activate
to start the upload process.
To Next Page
Loading...
