Dell POWERCONNECT 5524P - Page 363

Dell PowerConnect 55xx Systems User Guide 363
Managing Stacks Using the CLI Commands
The following table summarizes the CLI commands for setting fields
displayed in the Stack Unit ID page.
The following is an example of the CLI commands:
Table 9-69. Stack Unit ID CLI Commands
CLI Command Description
stack master unit
no stack master
Makes the unit specified be the Master unit.
Use the no version to restore the default
Master unit.
switch current-unit-number
renumber new-unit-number
Changes the unit ID of a specific unit.
console(config)# stack master unit 2
console(config)# switch 3 renumber 6