Dell POWERCONNECT 5524P - Page 372

372 Dell PowerConnect 55xx Systems User Guide
– IPv6 Address Type — When the server supports IPv6, this specifies
the type of static address supported. The possible options are:
•
Link Local — A Link Local address that is non-routable and used
for communication on the same network only.
•
Global — A globally unique IPv6 address; visible and reachable
from different subnets.
–
Link Local Interface — When the server supports an IPv6 Link Local
address, this specifies the Link Local interface. The possible options
are:
•
None — Disable the ISATAP tunnel.
•
ISATAP — The IPv6 interface is configured on an ISATAP
tunnel.
–
IP Address — Enter the receiver’s IP address.
4 Enter the fields:
–
Syslog Port Number — Port to which SYSLOG message are sent.
–
Maximum Header Size (Bytes) — Maximum number of bytes that
can be sent to the receiver in a single sample datagram (frame).
Adding an sFlow Receiver Using the CLI Commands
The following table summarizes the CLI commands for adding an sFlow
receiver.
Table 9-73. sflow Receiver CLI Commands
CLI Command Description
sflow receiver index {ipv4-
address|ipv6-address|hostname}
[port port] [max-datagram-size
bytes]
no sflow receiver index
Defines an sFlow receiver.
Use the no form of this command to
remove the definition of the receiver.
show sflow configuration
[port_id]
Displays the sFlow configuration for
ports that are enabled for Flow
sampling or Counters sampling.