482 Dell PowerConnect 55xx Systems User Guide
Protocol ports can either be attached to a
VLAN ID or a VLAN name.
–
VLAN ID (1- 4094)
—Check and enter a VLAN ID.
or
–
VLAN Name
— Check and enter a VLAN name.
Defining Protocol Ports Using CLI Commands
The following table summarizes the CLI command for defining protocol
ports.
The following is a sample of the CLI commands:
Table 14-4. Protocol Port CLI Commands
CLI Command Description
switchport general map
protocols-group group vlan
vlan-id
no switchport general map
protocols-group group
Sets a protocol-based classification rule.
Use the no form of this command to
delete a classification.
console (config-if)# switchport general map protocols-
group
1 vlan 8
To Next Page
Loading...
