EasyManua.ls Logo

Dell POWERCONNECT 5524P - Page 538

Dell POWERCONNECT 5524P
728 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
538 Dell PowerConnect 55xx Systems User Guide
Tx & Rx
— Enables LLDP on transmitting and receiving LLDP
packets.
Disable
— LLDP is disabled on the port.
4
Move the optional TLVs that the switch should advertise from the
Available TLV
list to the
Optional TLV
list. The TLVs advertise the
following:
Port Description
— Information about the port, including
manufacturer, product name, and hardware/software version.
System Name
— System's assigned name (in alpha-numeric format).
This value equals the sysName object.
System Description
— Description of the network entity (in alpha-
numeric format). This includes the system's name and versions of the
hardware, operating system, and networking software supported by the
switch. This value equals the sysDescr object.
System Capabilities
— Primary functions of the switch, and whether
or not these functions are enabled in the switch. The capabilities are
indicated by two octets. Bits 0 through 7 indicate Other, Repeater,
Bridge, WLAN AP, Router, Telephone, DOCSIS cable device, and
station respectively. Bits 8 through 15 are reserved.
802.3 MAC-PHY
— Duplex and bit rate capability and the current
duplex and bit rate settings of the sending device. It also advertises
whether the current settings are due to auto-negotiation or manual
configuration.
An alternative way to select the TLVs is to select the
Use Default
field, in
which case only mandatory TLVs are used. These are: Chassis subtype
(MAC address), Port subtype (port number), and TTL (time-to-leave).
5
Enter the
Management IP Address
that is advertised from the interface.
Check
Use Default
to use the default Management IP address.

Table of Contents

Related product manuals