562 Dell PowerConnect 55xx Systems User Guide
Configuring Trusted Interfaces Using CLI Commands
The following table summarizes the CLI commands for configuring the fields
in the
Trusted Interface pages.
The following is an example of some of the CLI commands:
Table 18-5. Configuring Trusted Interface Parameters CLI Commands
CLI Command Description
ip arp inspection trust
no ip arp inspection trust
Configures an interface trust state that
determines if incoming ARP packets are
inspected.
Use the no form of this command to
restore the default configuration.
show ip arp inspection
[[gigabitethernet|tengigabit
ethernet] port-number|port-
channel LAG-number]
Displays the ARP inspection configuration
for all interfaces or a specific interface.
console(config)# interface gi1/0/3
console(config-if)# ip arp inspection trust
To Next Page
Loading...
