592 Dell PowerConnect 55xx Systems User Guide
Defining iSCSI Targets Using CLI Commands
The following table summarizes the CLI commands for defining fields
displayed in the iS CSI Targets Tab le.
The following is an example of the CLI commands:
Table 20-2. iSCSI Targets Table CLI Commands
CLI Command Description
iscsi target port tcp-port-1
[tcp-port-2… tcp-port-8]
[address ip-address] [name
target-name]
no iscsi target port tcp-
port-1 [tcp-port-2… tcp-port-
8] [address ip-address]
Configures iSCSI port/s, target address
and name.
Use the no form of this command to
delete an iSCSI target.
show iscsi sessions Show the current iSCSI targets and
sessions.
console(config)# iscsi target port 30001 address
176.16.1.1 name iqn.1993-11.com.disk
vendor:diskarrays.sn.45678.tape:sys1.xyz
To Next Page
Loading...
