Dell PowerConnect 55xx Systems User Guide 687
Previously-defined policy bindings are displayed.
2
To bind a policy to an interface, click
Add
.
3
Select the interface assigned to the policy.
4
Select the
Policy Name
to be activated on the interface.
Defining Policy Binding Using CLI Commands
The following table summarizes the CLI commands for setting the fields in
the Policy Binding pages.
The following is an example of the CLI commands:
Table 22-18. Policy Binding CLI Commands
CLI Command Description
service-policy input
policy-map-name
no service-policy
input
Applies a policy map to the input of a particular
interface.
Use the no form of this command to detach a
policy map from an interface.
console(config-if)# service-policy input policy1
To Next Page
Loading...
