82 Dell PowerConnect 55xx Systems User Guide
1
Enter the
show version
command to verify which software version is
currently running on the device. The following is an example of the
information that appears:
2
Enter the
copy
{
tftp://|usb://
}
{tftp address}/{file
name} boot
command to copy the boot image to the device. The
following is an example of the information that appears:
3
Enter the
reload
command. The following message is displayed:
4
Enter
Y.
The device reboots.
console# show version
Unit SW version Boot version HW version
----- -------------- ----------------- ----------
2 1.0.0.24 1.0.0.11
console#
console# copy tftp://50.1.1.7/contax-10014.ros image
01-Oct-2006 11:57:35 %COPY-I-FILECPY: Files Copy - source URL
tftp://50.1.1.7/contax-10014.ros destination URL flash://image
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
01-Sep-2010 11:57:38 %INIT-I-Startup: Cold Startup
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
01-Sep-2010 11:59:05 %COPY-N-: The copy operation was completed
successfully!
Copy: 5954757 bytes copied in 00:01:30 [hh:mm:ss]
console# reload
This command will reset the whole system and
disconnect your current session. Do you want to
continue (Y/N) [N]?
To Next Page
Loading...
