Dell PowerEdge M1000e - Page 25

• Upload rmware image from TFTP server and start rmware update.
Synopsis
For SSH or Telnet or Serial:
racadm fwupdate -g -u -a <tftp_server_ip_address_or_FQDN> -d <path> [-m
<module>]
racadm fwupdate -f <ftp_server_ip_address_or_FQDN> <username> <password> -d
<path> [-m <module>]
racadm fwupdate -u -m iominf-<n>
racadm fwupdate -s [-m <module>]
racadm fwupdate -c [-m <module>]
For Remote RACADM:
racadm fwupdate -p -u -d <path> [-m <module>]
racadm fwupdate -g -u -a 192.168.0 -d firmimg.cmc -m cmc-active
When using FTP, if you provide the full path to the image le on the CLI, then the CMC uses that path to
locate that le on the host. If full path is not provided and the host system is running Linux or another variant
of UNIX , then CMC searches the home directory of the specied user for the le. If the host system is running
Windows, then a default folder, such as C:\ftproot is searched.
NOTE: When attempting to run rmware update task, if the rmware image path length is greater
than 256 characters, remote RACADM client exits with the error message "ERROR: Specified
path is too long".
NOTE: When attempting to run rmware update task using racadm fwupdate command, if the
rmware image path length is greater than 256 characters. Remote RACADM client exits with the
error message "ERROR: Specified path is too long".
Input
• —u — Performs the rmware update operation (used with -p and -g).
• —s — Displays the status of the rmware update. Use this option by itself. Lists active SD card features
and SD card status.
NOTE: Use —m to display the status of the module update. Omit -m to display the status of the active
CMC update.
NOTE: The value all is used only to obtain the status of all targets to update.
• -g — Downloads the rmware update using the TFTP server.
• -a — The IP Address option species the TFTP server IP address, used with -g option.
Species the TFTP server IP address or FQDN used for the rmware image (used with -g).
• -d — The -d, or directory option species the directory on the TFTP server or on CMC’s host server,
where the rmware update le resides.
Species the source path where the rmware image resides.
Default: Designated TFTP default directory on that host for the le if -g option is absent. If -g is used, it
defaults to a directory congured on the TFTP server.
• -p — Stops the current rmware update of a module.
NOTE: This option is only supported on the remote interface(s).
• -m <module> — Species the module or device to be updated. <module> is one of the following
values:
– cmc-active — default state if –m is not specied.
– cmc-standby
25