Dell PowerEdge M1000e - Sslresetcfg; Testemail

To run this subcommand, you must have the Congure chassis administrator privilege.
Synopsis
• racadm sslcsrgen -g
• racadm sslcsrgen [-g] [-f <filename>]
• racadm sslcsrgen -s
Input
• -g — Generates a new CSR.
• -s — Returns the status of a CSR generation process (generation in progress, active, or none).
• -f — Species the lename of the location, <filename>, where the CSR is downloaded.
NOTE:
• If the -f option is not specied, the lename defaults to sslcsr in your current directory.
• The -f option is only supported on the remote interface(s).
Output If no options are specied, a CSR is generated and downloaded to the local le system as sslcsr by default. The
-g option cannot be used with the -s option, and the -f option can only be used with the -g option.
The sslcsrgen -s subcommand returns one of the following status codes:
• CSR was generated successfully.
• CSR does not exist.
Example
• Display current status of CSR operation:
racadm sslcsrgen -s
or
racadm sslcsrgen -g -f c:\csr\csrtest.txt
• Generate and download a CSR to local lesystem:
racadm -r 192.168.0.120 -u root -p calvin sslcsrgen -g -f csrtest.txt
NOTE: Before a CSR can be generated, the CSR elds must be congured in the RACADM config —g
cfgracsecurity group. For example:
racadm config -g cfgracsecurity -o cfgRacSecCsrCommonName cmc-effort.cmc.com
NOTE: In Telnet or SSH console, you can only generate and not download the CSR le.
sslresetcfg
Description
Restores the web-server certicate to factory default and restarts web-server. The certicate takes eect 30
seconds after the command is entered.
To run this subcommand,you must have the Chassis Conguration Administrator privilege.
Synopsis
racadm sslresetcfg
Input N/A
Example
racadm sslresetcfg
Certificate generated successfully and webserver restarted.
testemail
Description
Sends a test email from CMC to a specied destination. Prior to running the test email command, make sure that
the SMTP server is congured.
75