Figure 73. Installing the liquid cooling module
Next steps
1. Install the expansion card riser.
2. Installing the air shroud.
3. Follow the procedure listed in the After working inside your system.
Expansion cards and expansion card risers
NOTE:
A system event entry is logged in the iDRAC Lifecycle Controller if an expansion card riser is not supported
or missing. It does not prevent your system from getting powered on. However, if a F1/F2 pause occurs with an
error message, see Troubleshooting expansion cards section in the Dell PowerEdge Servers Troubleshooting Guide at
www.dell.com/poweredgemanuals.
Installing and removing system components 111
To Next Page
Loading...
