Dell PowerEdge R760xa - System Health and ID Indicator Codes

System health and system ID indicator codes
The system health and system ID indicator is located on the left control panel of the system.
Figure 159. System health and system ID indicator
Table 86. System health and system ID indicator codes
System health and system ID indicator code Condition
Solid blue Indicates that the system is powered on, is healthy, and
system ID mode is not active. Press the system health and
system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system
health and system ID button to switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem
persists, see the Getting help section.
Blinking amber Indicates that the system is experiencing a fault. Check
the System Event Log for specific error messages. For
information about the event and error messages generated
by the system firmware and agents that monitor system
components, go to qrl.dell.com > Look Up > Error Code,
type the error code, and then click Look it up.
194 System diagnostics and indicator codes