Figure 113. Installing the VGA port
3. Connect the VGA port cable to the LC rear I/O board.
4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated
on the system board connector.
6. Tighten the captive screws on the system.
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
Optional BOSS-N1 module
Removing the BOSS-N1 module blank
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Steps
Use a screwdriver to push out the blank from the BOSS-N1 module bay.
Installing and removing system components
145
To Next Page
Loading...
