Dell PowerEdge R760xa - System Battery; Replacing the System Battery

Figure 127. Installing the BOSS-N1 shroud
2. Push the BOSS-N1 shroud into hook on cage and fasten screw to fix the BOSS shroud.
Next steps
1. Follow the procedure listed in After working inside your system.
System battery
This is a service technician replaceable part only.
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions. that came with your system for more information.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If applicable, disconnect the power or data cables from the expansion cards.
4. Remove the expansion card risers.
156
Installing and removing system components