Dell PowerEdge R760xa - Removing the GPU Riser Module Card Holders; Installing the GPU Riser Module Card Holders

Next steps
1. Install the GPU riser module.
2. Install the sponges.
3. Install the rear mounting front PERC module.
4. Follow the procedure listed in After working inside your system.
Removing the GPU riser module card holders
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the GPU riser module.
NOTE: Your system has only half height (HH) GPU card holder.
Steps
Loosen the captive screw and pull out the HH GPU card holder form the GPU riser module.
Figure 108. Removing the HH card holder
Next steps
1. Replace the GPU riser module holders.
Installing the GPU riser module card holders
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the GPU riser module.
NOTE: Your system has only half height (HH) GPU card holder.
Steps
Insert the HH GPU card holder into the GPU riser module and tighten the captive screw.
140
Installing and removing system components