Figure 97. Installing the left GPU riser module
Next steps
1. If removed, install the sponges.
2. Connect the riser board power and signal cables to the system board.
3. Install the cooling fan cage assembly.
4. Install the air shroud.
5. Connect the GPU power, signal, and BP/PERC cables to the system board.
6. Follow the procedure listed in After working inside your system.
Removing the GPU
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If installed, remove the sponges.
4. Remove the GPU riser module.
5. If installed, remove the bridge cards.
Steps
1. To remove the GPU from GPU riser module:
a. Disconnect the GPU power cable from the GPU card.
b. Open the GPU card holder latches on both ends of the riser.
c. Pull the hockey stick by the pull tape.
d. Hold the GPU card by the edges and pull the card from the riser.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 131
To Next Page
Loading...
