Figure 46. Installing the rear mounting front PERC module
Next steps
1. Connect all the cables to rear mounting front PERC module.
NOTE: Route the cables properly to prevent the cables from being pinched or crimped.
2. Install the drive backplane cover.
3. Follow the procedure listed in After working inside your system.
Drive backplane
This is a service technician replaceable part only.
Drive backplane
Depending on your system configuration, the drive backplanes that are supported are listed here:
Table 62. Supported backplane options
System Supported hard drives options
PowerEdge R760xa
2.5-inch (x 8) NVMe backplane
2.5-inch (x 8) SAS, or SATA backplane
84 Installing and removing system components
To Next Page
Loading...
