Table 76. Config 1. RF1B+RF2B+R1V+R4T (continued)
Card type Slot priority Maximum number of cards
Mellanox (NIC: NDR200) 1 1
Mellanox (NIC: NDR) 1 1
Mellanox (NIC: HDR100 VPI) 2, 7, 1 3
Mellanox (NIC: 100Gb) 2, 7, 1 3
Broadcom (NIC: 100Gb) 2, 7, 1 3
Intel (NIC: 100Gb) 2, 7, 1 3
Intel (NIC: 25Gb) 2, 7, 1 3
Broadcom (NIC: 25Gb) 2, 7, 1 3
Mellanox (NIC: 25Gb) 2, 7, 1 3
Broadcom (HBA:FC64) 2, 7, 1 3
Broadcom (HBA: FC32) 2, 7, 1 3
Qlogic (Marvell) (HBA: FC32) 1 1
Broadcom (NIC: 10Gb) 2, 7, 1 3
Intel (NIC: 10Gb) 2, 7, 1 3
Intel (NIC: 1Gb) 2, 7, 1 3
Broadcom (NIC: 1Gb) 2, 7, 1 3
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If applicable, disconnect the cables from the expansion card or system board.
NOTE: Only Riser 1 and Riser 4 are supported.
WARNING: If BOSS-N1 module is installed, ensure to disconnect the BOSS-N1 power cable before removing riser
3 blank, Riser 1 or Riser 4.
Figure 81. Disconnecting the BOSS-N1 power cable
Installing and removing system components
119
To Next Page
Loading...
