Dell PowerEdge R760xa - Installing the Bridge Cards

Figure 104. Removing the bridge cards
2. If you are not replacing the bridge cards, Install the cover into the GPU card.
Figure 105. Installing the cover
Next steps
1. Replace the bridge cards.
Installing the Bridge Cards
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the rear mounting front PERC module.
NOTE: Observe the cable routing before disconnecting the cables.
4. Remove the sponges.
5. Remove the GPU riser module.
6. If installed, take out the GPU card and remove the slot cover on the GPU card.
138
Installing and removing system components