Figure 44. Installing a NVMe drive blank
Next steps
1. Install all drives.
2. If removed, install the front bezel.
3. If removed, install the drive backplane.
4. If removed, install the drive backplane cover.
PERC module
Removing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the drive backplane cover.
4. Disconnect all the cables from rear mounting front PERC module, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the rear mounting front PERC module.
2. Slide out the rear mounting front PERC module to disengage from the connector on the drive backplane.
82
Installing and removing system components
To Next Page
Loading...
