Dell PowerEdge R760xa - Ports and Connectors Specifications; USB Ports Specifications; NIC Port Specifications; Serial Connector Specifications

Infrastructure > Storage Adapters & Controllers > Dell PowerEdge Express Flash NVMe PCIe SSD > Select This
Product > Documentation > Manuals and Documents.
Ports and connectors specifications
USB ports specifications
Table 18. PowerEdge R760xa USB specifications
Front Rear Internal (Optional)
USB port type No. of ports USB port type No. of ports USB port type No. of ports
USB 2.0-
compliant port
One USB 3.0-
compliant port
One Internal USB 3.0-
compliant port
One
iDRAC Direct port
(Micro-AB USB
2.0-compliant
port)
One USB 2.0-
compliant port
One
NOTE: The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port.
NIC port specifications
The PowerEdge R760xa system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports embedded on
the LAN on Motherboard (LOM) and integrated on the optional Open Compute Project (OCP) card.
Table 19. NIC port specification for the system
Feature Specifications
LOM card (optional) 1 GbE x 2
OCP card (OCP 3.0) (optional) 1 GbE x 4, 10 GbE x 2, 10 GbE x 4, 25 GbE x 2, 25 GbE x 4
NOTE: The system should have either LOM card or an OCP card that is installed in the system.
NOTE: On the system board, the supported OCP PCIe width is x8; when x16 PCIe width is installed, it is downgraded to x8.
Serial connector specifications
The PowerEdge R760xa system supports one optional card type serial connector, which is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant.
The optional serial connector card is installed similar to an expansion card filler bracket.
VGA ports specifications
The PowerEdge R760xa system supports DB-15 VGA port on front panel and on rear I/O board (optional for Direct Liquid
Cooling configuration).
Video specifications
The PowerEdge R760xa system supports integrated Matrox G200 graphics controller with 16 MB of video frame buffer.
26
Technical specifications