Dell PowerEdge R760xa - System Memory Installation

NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 69. Configuration 4: 8 x 2.5-inch SAS_SATA fPERC12
Order From To
1. SIG_PWR_1 (system board power connector) BP_PWR_1 (Front backplane
power connector)
2. SL11_CPU2_PB6 (signal connector on system board) CTRL_DST_PA1 (fPERC input
connector)
3. SL12_CPU2_PA6 (signal connector on system board) CTRL_DST_PB1 (fPERC input
connector)
4. CTRL_SRC_SA1_PA1 (adapter PERC controller connector) BP_DST_SA1 (backplane
expander signal connector)
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
System memory
System memory guidelines
The PowerEdge R760xa system supports DDR5 registered DIMMs (RDIMMs). System memory holds the instructions that are
started by the processor.
Your system memory is organized into eight channels per processor (two memory sockets per channel),16 memory sockets per
processor and 32 memory sockets per system.
94
Installing and removing system components