Figure 100. Removing the GPU blank
2. To install the GPU on GPU riser module:
a. Align the connector on the GPU with the connector on the riser.
b. Insert the GPU into the riser until firmly seated.
c. Close the GPU card holder latches on both ends of the riser.
d. Pull hockey stick by the pull tape, to assemble the GPU card into GPU riser.
e. Connect the GPU power cable to the GPU card.
NOTE:
For the SW GPU card to be installed, GPU card holder is required see Installing the GPU riser module card
holder.
134 Installing and removing system components
To Next Page
Loading...
