Figure 155. Installing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. Install the BOSS-N1 module. To install the BOSS-N1 , see installing the BOSS-N1 module steps 1 to 5.
2. Install the M.2 SSD. To install the M.2 SSD, see installing the BOSS-N1 module steps 6 to 10.
NOTE:
Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 module.
To remove the BOSS-N1 module:
1. Power off the system and remove the system cover.
2. Remove the M.2 SSD. To remove the M.2 SSD, see removing the BOSS-N1 module steps 1 to 4.
3. Remove the BOSS-N1 module. To remove the BOSS-N1 module, see removing the BOSS-N1 module steps 5 to 8.
4. Install the BOSS blank.
NOTE:
Removal of the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when removing the BOSS-N1 module.
NOTE: Disconnect the BOSS signal cable and the BOSS power cable before lifting the controller card module from the
system.
Upgrade Kits 183
To Next Page
Loading...
