Script Commands 161
NOTE: You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
host Name of the host for which you are
defining an HBA host port. You must put
quotation marks (" ") around the host
name.
NOTE: An HBA host port is a physical
connection on a host adapter that resides
within a host system. An HBA host port
provides host access to the virtual disks in
a storage array. If the host bus adapter has
only one physical connection (one host
port), the terms host port and host bus
adapter are synonymous.
interfaceType The identifier for the type of interface for
the host port.
Yo u mu s t e n t e r SAS. If you do not enter
SAS, the command attempts to use an
invalid type of interface. A SAS selection
requires an 8-byte WWID.
Parameter Description
book.book Page 161 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
