Dell PowerVault MD3620f - Show Remote Replication Virtual Disk Candidates

Script Commands 279
Show Remote Replication Virtual Disk Candidates
NOTE: This command valid only with Fibre Channel storage arrays.
This command returns information about the candidate virtual disks on a
remote storage array that can be used as secondary virtual disks in a Remote
Replication configuration.
Syntax
show remoteReplication candidates primary=
”virtualDiskName”
remoteStorageArrayName=storageArrayName
Parameters
Parameter Description
primary The name of the local virtual disk that you want for
the primary virtual disk in the remote-replicated
pair. Enclose the primary virtual disk name in
double quotation marks (“ ”).
remoteStorageArrayName The remote storage array that contains possible
virtual disks for a secondary virtual disk. If the
remote storage array name has special characters, it
must be enclosed in double quotation marks (“ ”).
book.book Page 279 Wednesday, June 8, 2011 12:20 PM