Dell PowerVault MD3620f - Deactivate Remote Replication

Script Commands 185
Deactivate Remote Replication
NOTE: This command valid only with Fibre Channel storage arrays.
This command deactivates the Remote Replication premium feature,
disassembles the replication repository virtual disk, and releases the RAID
controller module owner of the secondary virtual disk. The RAID controller
module host port that is dedicated to the secondary virtual disk is available
for host data transfers.
Syntax
deactivate storageArray feature=remoteReplication
Parameters
None.
copyPriority Specifies the priority that a virtual disk
copy has relative to host I/O activity. Valid
entries are highest, high, medium, low, or
lowest.
NOTE: CopyPriority defines the amount of
system resources used to copy the data
between the source virtual disk and target
virtual disk of a virtual disk-copy pair. If you
select the highest priority level, the virtual
disk copy uses the most system resources
to perform virtual disk copy, which
decreases performance for host data
transfers.
targetReadOnlyEnabled Specifies whether the target virtual disk is
write enabled or read only. To be able to
write to the target virtual disk, set this
parameter to FALSE. To prevent writing
to the target virtual disk, set this
parameter to TRUE.
Parameter Description
book.book Page 185 Wednesday, June 8, 2011 12:20 PM