Dell PowerVault MD3620f - Start Enclosure Blink; Start Iscsi DHCP Refresh

Script Commands 297
Start Enclosure Blink
This command identifies an enclosure by turning on the indicator LED. (Use
the stop enclosure blink command to turn off the indicator LED for the
enclosure.)
Syntax
start enclosure [enclosureID] blink
Parameter
Start iSCSI DHCP Refresh
This command initiates a refresh of the DHCP parameters for the iSCSI
interface. If the configuration method for the interface is not set to DHCP,
the procedure returns an error.
Syntax
start controller [(0 | 1)] iscsiHostPort [(1 | 2 |
3 | 4)] dhcpRefresh
Parameters
NOTE: This operation ends the iSCSI connections for the portal and brings down
the portal temporarily.
Parameter Description
enclosure Identifies the enclosure to blink. Enclosure ID
values are 0 to 99. You must put brackets ([ ])
around the enclosure ID value.
Parameter Description
controller The identifier letter of the RAID controller module that has the
iSCSI host ports. Valid RAID controller module identifier values are
0 or 1, where, 0 is the RAID controller module in slot 0, and 1 is the
RAID controller module in slot 1.
iscsi-
host-port
The identifier of the port on the storage array on which you want to
refresh the DHCP parameters. Enclose the iSCSI host port name in
square brackets
([ ]).
book.book Page 297 Wednesday, June 8, 2011 12:20 PM