268 Script Commands
Set Virtual Disk Copy
This command defines the properties for a virtual disk copy pair.
Syntax
set virtualDiskCopy target [targetName] [source
[sourceName]] copyPriority=(highest | high |
medium | low | lowest) targetReadOnlyEnabled=(TRUE
| FALSE)
Parameters
NOTE: When using this command, you can specify one or more of the parameters.
You do not, however, need to use all of the parameters.
Parameter Description
target Specifies the name of the target virtual disk for which
to define properties. You must put brackets ([ ])
around the target virtual disk name. If the target
virtual disk name has special characters, you must also
put quotation marks (" ") around the target virtual
disk name.
source Specifies the name of the source virtual disk for which
to define properties. You must put brackets ([ ])
around the source virtual disk name. If the source
virtual disk name has special characters, you must also
put quotation marks (" ") around the source virtual
disk name.
copyPriority Specifies the priority that the virtual disk copy has
relative to host I/O activity. Valid entries are highest,
high, medium, low, or lowest.
targetReadOnlyEnabled Specifies whether the target virtual disk is write
enabled or read only. To be able to write to the target
virtual disk, set to FALSE. To prevent writing to the
target virtual disk, set to TRUE.
book.book Page 268 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
