228 Script Commands
NOTE: For configurations with more than 32 virtual disks, it is recommended you
quiesce host I/O operations when executing this command.
Set Disk Group Forced State
This command moves a disk group into a Forced state. Use this command if
the start diskGroup import command does not move the disk group to an
Imported state or if the import operation does not work because of hardware
errors. In a Forced state, the disk group can be imported, and you can then
identify the hardware errors.
Syntax
set diskGroup [diskGroupName] forcedState
Parameter
NOTE: You can move the physical disks that comprise a disk group from one
storage array to another storage array. The CLI provides three commands that let
you move the physical disks. The commands are start diskGroup export, start
diskGroup import, and set diskGroup forcedState. In the Forced state, you can
perform an import operation on the disk group.
Parameter Description
diskGroup Sequence number of the disk group for which to
set properties. You must put brackets ([ ]) around
the disk group number.
book.book Page 228 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
