Dell PowerVault MD3620f - Set Physical Disk State; Set RAID Controller Module

Script Commands 241
Set Physical Disk State
This command sets a physical disk to the Failed state. (To return a physical
disk to the optimal state, use the revive physicalDisk command.)
Syntax
set (physicalDisk [enclosureID,slotID] |
physicalDisks [enclosureID1,slotID1 enclosureID2,
slotID2 ... enclosureIDn,slotIDn])
operationalState=failed
Parameter
Set RAID Controller Module
This command defines the attributes for the RAID controller modules.
Syntax
set controller [(0 | 1)]
availability=(online | offline | serviceMode) |
ethernetPort [(1 | 2)]=ethernetPortOptions |
globalNVSRAMByte [nvsramOffset]=
(nvsramByteSetting |
nvsramBitSetting) |
hostNVSRAMByte [hostType, nvsramOffset]=
(nvsramByteSetting |
nvsramBitSetting) |
IPv4GatewayIP=ipAddress |
IPv6RouterAddress=ipv6Address |
iscsiHostPort [(1 | 2 | 3 | 4)]=
Parameter Description
physicalDisk or
physicalDisks
The enclosure and the slot where the physical
disk resides. Enclosure ID values are 0 to 99. Slot
ID values are 0 to 31. Enclose the enclosure ID
values and the slot ID values in square brackets ([
]).
book.book Page 241 Wednesday, June 8, 2011 12:20 PM