Dell PowerVault MD3620f - Re-Create Remote Replication Repository Virtual Disk

204 Script Commands
Re-create Remote Replication Repository Virtual Disk
NOTE: This command valid only with Fibre Channel storage arrays.
This command creates a new Remote Replication repository virtual disk (also
called a replication repository virtual disk) by using the parameters defined for
a previous replication repository virtual disk. The underlying requirement is
that you have previously created a replication repository virtual disk. When
using this command, the replication repository virtual disk can be defined in
one of three ways:
• User-defined physical disks
• User-defined disk group
• User-defined number of physical disks
If you choose to define a number of physical disks, the RAID controller
module firmware chooses which physical disks to use for the replication
repository virtual disk.
Syntax
User-Defined Physical Disks
recreate storageArray replicationRepository
repositoryRAIDLevel=(1 | 5 | 6)
repositoryPhysicalDisks=(enclosureID1,slotID1 ...
enclosureIDn,slotIDn)
repositoryDiskGroupUserLabel=[diskGroupName]
[enclosureLossProtect=(TRUE | FALSE)]
User-Defined Disk Group
recreate storageArray replicationRepository
repositoryDiskGroup=diskGroupName
[freeCapacityArea=freeCapacityIndexNumber]
User-Defined Number of Drives
recreate storageArray replicationRepository
repositoryRAIDLevel=(1 | 5 | 6)
repositoryPhysicalDiskCount=numberOfPhysicalDisks
[enclosureLossProtect=(TRUE | FALSE)]
book.book Page 204 Wednesday, June 8, 2011 12:20 PM