Dell PowerVault MD3620f - Page 205

Script Commands 205
Parameters
Parameter Description
repositoryRAIDLevel The RAID level for the replication
repository virtual disk. Valid values are 1, 5,
or 6.
repositoryPhysicalDisks The physical disks for the replication
repository virtual disk. Specify the enclosure
ID and slot ID for each physical disk that
you assign to the replication repository
virtual disk. Enclosure ID values are 0 to 99.
Slot ID values are 1 to 32. Enclose the
enclosure ID values and the slot ID values
in parentheses.
repositoryDiskGroup The name of the disk group where the
replication repository virtual disk is located.
freeCapacityArea The index number of the free space in an
existing disk group that you want to use to
re-create the replication repository virtual
disk. Free capacity is defined as the free
capacity between existing virtual disks in a
disk group. For example, a disk group might
have the following areas: virtual disk 1, free
capacity, virtual disk 2, free capacity, virtual
disk 3, free capacity. To use the free capacity
following virtual disk 2, you would specify:
freeCapacityArea=2
Run the show diskGroup command to
determine if a free capacity area exists.
repositoryPhysicalDiskCount The number of unassigned physical disks
that you want to use for the replication
repository virtual disk.
enclosureLossProtect The setting to enforce enclosure loss
protection when you create the replication
repository virtual disk. To enforce enclosure
loss protection, set this parameter to TRUE.
The default value is FALSE.
book.book Page 205 Wednesday, June 8, 2011 12:20 PM