Script Commands 237
Set iSCSI Initiator
This command sets the attributes for an iSCSI initiator.
Syntax
set iscsiInitiator ([“iscsiID“]|
userLabel=”newName” |
host=”newHostName” |
chapSecret=”newSecurityKey”)
Parameters
NOTE: Challenge Handshake Authentication Protocol (CHAP) is a protocol that
authenticates the peer of a connection. CHAP is based upon the peers sharing a
“secret.” A secret is a security key that is similar to a password.
NOTE: Use the
chapSecret
parameter only for initiators requiring
mutual authentication.
Parameter Description
iscsiID The name of the iSCSI initiator for which you want to set attributes.
userLabel The new name that you want to use for the iSCSI initiator.
host The name of the new host to which the HBA host port is connected.
Enclose the host name in double quotation marks (" ").
chapSecret The password that you want to use to authenticate a peer connection.
book.book Page 237 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
