Dell PowerVault MD3620f - Page 184

184 Script Commands
Syntax
create virtualDiskCopy source=”sourceName”
target=”targetName”
[copyPriority=(highest | high | medium | low |
lowest)
targetReadOnlyEnabled=(TRUE | FALSE)]
Parameters
Parameter Description
source Name of an existing virtual disk to use as
the source virtual disk. You must put
quotation marks (" ") around the source
virtual disk name.
NOTE: You can use any combination of
alphanumeric characters, hyphens, and
underscores for the names. Command
names can have a maximum of 30
characters. If you exceed the maximum
character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome
this limitation.
target Name of an existing virtual disk to use as
the target virtual disk. You must put
quotation marks (" ") around the target
virtual disk name.
NOTE: You can use any combination of
alphanumeric characters, hyphens, and
underscores for the names. Command
names can have a maximum of 30
characters. If you exceed the maximum
character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome
this limitation.
book.book Page 184 Wednesday, June 8, 2011 12:20 PM