Dell PowerVault MD3620f - Page 163

Script Commands 163
capacity=virtualDiskCapacity
owner=(0 | 1)
cacheReadPrefetch=(TRUE | FALSE)
segmentSize=segmentSizeValue
usageHint=(fileSystem | dataBase | multiMedia)
enclosureLossProtect=(TRUE | FALSE)
dssPreAllocate=(TRUE | FALSE)
securityType=(none | capable | enabled)]
Parameters
Parameter Description
physicalDiskCount Number of unassigned physical disks to
use in the disk group.
NOTE: The physicalDiskCount parameter
enables you to choose the number of
physical disks to use in the disk group. You
do not need to specify the physical disks by
enclosure ID and slot ID. The RAID
controller modules choose the specific
physical disks to use for the disk group.
diskGroupUserLabel The alphanumeric identifier (including –
and _) that you want to give the new disk
group. Enclose the disk group identifier in
double quotes (" ").
raidLevel RAID level of the disk group that contains
the virtual disk. Valid values are 0, 1, 5
or 6.
userLabel Name to give to the new virtual disk. You
must put quotation marks (" ") around
the new virtual disk name.
physicalDiskType Specifies the type of physical disk to use
in the virtual disk. You cannot mix
physical disk types in the virtual disk. The
valid physical disk type is SAS.
book.book Page 163 Wednesday, June 8, 2011 12:20 PM