170 Script Commands
raidLevel RAID level of the disk group that contains the virtual
disk. Valid values are 0, 1, 5, or 6.
NOTE: If you set the
raidLevel
parameter to RAID 1, the
RAID controller module firmware takes the list of
physical disks and pairs them using the following
algorithm:
Data physical disk =
X
Consistency physical disk =
where,
X
goes from 1 to and
N
is the number of
physical disks in the list. The following data show an
example of six physical disks and their mirror pairs.
Data Consistency
1
2
3
userLabel Name that you want to give the new virtual disk. You
must put quotation marks (" ") around the new virtual
disk name.
NOTE: You can use any combination of alphanumeric
characters, hyphens, and underscores for the names.
Spaces are not allowed. Names can have a maximum of
30 characters.
capacity Size of the virtual disk that you are adding to the
storage array. Size is defined in units of bytes, KB, MB,
GB, or TB.
NOTE: If you do not specify a capacity, all physical disk
capacity available in the disk group is used. If you do not
specify capacity units, bytes are used as the default. A
space must be added between the last digit and the size
(MB, GB, or KB) for values greater than 9.
Parameter Description
book.book Page 170 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
