Dell PowerVault MD3620f - Page 192

192 Script Commands
testID Identifier for the diagnostic test to run.
The identifier and corresponding tests
are:
1 — Reads the test
2 — Write test
3 — Data loop-back test
NOTE: When you run a data loop-back test,
you can optionally specify a file that
contains a data pattern. If you do not
specify a file, the RAID controller module
firmware provides a default pattern.
patternFile File path and file name of the file that
contains a data pattern to use as test data.
Enclose the path and file name with
quotation marks (" ").
Parameter Description
book.book Page 192 Wednesday, June 8, 2011 12:20 PM