200 Script Commands
Syntax
enable diskGroup [diskGroupName] security
Parameter
Additional Information
To successfully run this command, the following conditions must be met:
All physical disks in the disk group must be self-encrypting disk (SED)
physical disks.
• The Physical Disk Security premium feature must be enabled.
• The storage array security key has to be set.
• The disk group is Optimal, and it does not have snapshot virtual disks or
repository virtual disks.
The RAID controller module firmware creates a lock that restricts access to
the SED physical disks. SED physical disks have a state called Security
Capable. When you create a security key, the state is set to Security Enabled,
which restricts access to all SED physical disks that exist within the storage
array.
Parameter Description
diskGroup The alphanumeric identifier (including -
and _) of the disk group that you want to
place in the Security Enabled state.
Enclose the disk group identifier in square
brackets ([ ]).
book.book Page 200 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
