22 About the Command Line Interface
-g Use to specify an ASCII file that contains e-mail sender
contact information to include in all e-mail alert
notifications. The CLI assumes the ASCII file is text only,
without delimiters or any expected format. A typical file
contains the following information:
•Name
•Title
•Company
• Phone
•Pager
NOTE: You can use any file name that your operating system
supports. You must not use userdata.txt. Some operating
systems reserve userdata.txt for system information.
-h Use with the -a and -x parameters to specify the host name
that is running the SNMP agent to which the storage array
is connected.
-I Use to specify the type of information to be included in
the e-mail alert notifications. The following are valid
information arguments:
•
eventOnly
— Only event information is included in
the e-mail.
•
profile
— Event and array profile information is included
in the e-mail.
•
supportBundle
— Event and support bundle
information is included in the e-mail.
NOTE: You can enter only one information argument each
time you execute the command. If you want all of the
information, you must run the command three times.
-i Use with the -d parameter to display the IP address of the
known storage arrays.
-m Use to specify the host name or IP address of the e-mail
server from which to send e-mail alert notifications.
Table 1-2. Command Line Parameters
(continued)
Parameter Definition
book.book Page 22 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
