Script Commands 233
NOTE: When you use this command, you can specify one or more of the optional
parameters. You do not, however, need to use all of the parameters.
NOTE: You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Host Group Parameter Host Has Individual Virtual
Disk-to-LUN Mappings
Host Does Not Have Individual
Virtual Disk-to-LUN Mappings
hostGroupName The host is removed from
the present host group and is
placed under the new host
group defined by
hostGroupName.
The host is removed from the
present host group and is
placed under the new host
group defined by
hostGroupName.
none The host is removed from
the host group as an
independent partition and is
placed under the root node.
The host is removed from the
present host group and is
placed under the default
group.
defaultGroup The command fails. The host is removed from the
present host group and is
placed under the default
group.
book.book Page 233 Wednesday, June 8, 2011 12:20 PM
To Next Page
Loading...
