Dell PowerVault MD3620f - Page 40

40 About the Script Commands
nvsram-offset hexadecimal-literal
host-type string-literal | integer-literal
nvsram-byte-setting nvsram-value
(0x hexadecimal | integer-literal)
nvsram-bit-setting nvsram-mask, nvsram-value
(0x hexadecimal, 0x hexadecimal |
integer-literal)
ipv4-address (0–255).(0–255).(0–255).(0–255)
ipv6-address (0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFFF):(0-FFFF):
(0-FFFF):(0-FFF)
autoconfigure-vols-attr-value-list autoconfigure-vols-attr-value-pair
{autoconfigure-vols-attr-value-pair}
autoconfigure-vols-attr-value-pair physicalDiskType=physical disk-type|
raidLevel=raid-level |
diskGroupWidth=integer-literal |
diskGroupCount=integer-literal |
virtualDisksPerGroupCount=integer-
literal|
hotSpareCount=integer-literal |
segmentSize=segment-size-spec
NOTE: The physicalDiskType parameter is
not required if only one type of physical
disk is in the storage array. If you use the
physicalDiskType parameter, you must
also use the hotSpareCount and
diskGroupWidth parameters. If you do not
use the physicalDiskType parameter, the
configuration defaults to SAS physical
disks.
NOTE: The virtualDisksPerGroupCount
parameter is the number of equal-
capacity virtual disks per disk group.
Table 2-4. Recurring Syntax Elements
(continued)
Recurring Syntax Syntax Value
book.book Page 40 Wednesday, June 8, 2011 12:20 PM