Steps
1. Connect the battery cable to its connector on the battery and route it using the routing channel.
2. Readhere the adhesive on the battery cable and flip the battery.
3. Align the tabs on the battery at an angle with the tab holes on the system chassis.
4. Place the battery onto its slot in the system chassis.
5. Replace the three (M2x7) screws to secure the battery to the system chassis.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
SIM card
Removing the SIM card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
About this task
The figure indicates the location of the SIM card and provides a visual representation of the removal procedure.
Removing and installing components
25
To Next Page
Loading...
