Steps
1. Align and place the power button into its slot on the computer.
2. Replace the two (M2x2) screws to secure the power button in place.
Next steps
1. Install the power button board.
2. Install the heat-sink for discrete graphics.
3. Install the base cover.
4. Follow the procedure in after working inside your computer.
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the primary solid-state drive.
4. Remove the secondary solid-state drive.
5. Remove the battery.
About this task
The figure indicates the location of the speakers and provides a visual representation of the removal procedure.
Removing and installing components
59
To Next Page
Loading...
