2. Install the memory module.
3. Install the heat sink.
4. Install the WLAN card.
5. Install the SSD-1 (M.2 2280 solid-state drive or M.2 2230 solid-state drive).
6. Install the SSD-2 (M.2 2280 solid-state drive or M.2 2230 solid-state drive).
7. Install the battery.
8. Install the base cover.
9. Follow the procedure in after working inside your computer.
DC-in port
Removing the DC-in
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The figure indicates the location of the DC-in and provides a visual representation of the removal procedure.
Disassembly and reassembly
49
To Next Page
Loading...
