Table 7. Connection (continued)
Option Description
use any enabled NICs when UEFI networking protocols are
installed and available.
The options are:
● Disabled
● Enabled
● Enabled with PXE - This option is enabled by default.
Wireless Device Enable
Allows you to enable or disable the internal wireless devices.
The options are:
● WLAN
● Bluetooth
Both the options are enabled by default.
Enable UEFI Network Stack
Allows you to control the onboard LAN controller. It allows
pre-OS and early operating system networking features to
use any enabled NICs when UEFI networking protocols are
installed and available.
Enable UEFI Network Stack - This option is enabled by
default.
Power management
Table 8. Power Management
Option Description
Battery Configuration
Allows the system to run on battery during peak power usage hours.
The options are:
● Adaptive—enabled by default
● Standard
● ExpressCharge
● Primarily AC Use
● Custom
NOTE: If Custom Charge is selected, you can also configure Custom Charge Start and
Custom Charge Stop.
Advanced Configuration
This option enables you to maximize the battery health.
By default, the Enable Advanced Battery Charge Mode option is disabled.
NOTE: The user can charge battery using feature Beginning of Day and Work Period.
By default, Work Period is disabled.
Use ExpressCharge for accelerated battery charging.
Peak Shift
Allows the system to run on battery during peak power usage hours.
Peak Shift - By default, this option is disabled.
NOTE: The user can:
● Set Battery Threshold Min = 15, Max = 100
● Prevent AC power between certain times of the day using Peak Shift Start, Peak Shift
End, and Peak Shift Charge Start.
System setup 69
To Next Page
Loading...
